BEAST Components Hybrid Bar IR 31.8 Carbon Handlebars

The Hybrid Bar IR 31.8 carbon handlebars from BEAST Components for a high-end cockpit

The Hybrid Bar IR by BEAST Components is made of carbon and is suitable for you if you want to use a classic mountain bike drivetrain on your gravel bike or if you want to convert your MTB to a drop bar cockpit. The integrated hoods offer your hands hold, while the brake lever can be comfortably attached. Interface Reinforcement increases the durability of contact points with other components, such as the stem. The handlebars offer you a full 20° of flare. This gives you optimum control of your gravel bike even in the drops. When the going gets tough, you'll be back in the hoods in no time thanks to the low 95mm drop.

Specifications:

Application:

Gravel, All Mountain

Width:

460 mm (centre-centre)

Note:

With BEAST Components, the handlebar width is measured in the centre of the shift/brake lever attachment.

Stem Clamp:

31.8 mm

Technical Information:

Drop:

95 mm

Backsweep:

4°

Flare:

20°

Cable Routing:

external

Material:

carbon

Approved For:

Stem Clamp Width:

100 mm

Features:

• carbon handlebars for use with MTB shift levers and brake levers on gravel bikes
• protective layer through Interface Reinforcement at all contact points
• handmade in Germany

Technology:

Intended Use Category 3
Suitable for use on paths, such as paved and unpaved hiking trails, where roots, thresholds, stones and steps are found frequently, but the wheels are in constant contact with the ground or lose contact with the ground for short periods due to uneven surfaces such as roots. Steps of up to 15 cm, e.g. kerbs, can be ridden down.

Interface Reinforcement
The contact points of handlebars and seatposts are covered with a protective layer. This withstands punctual loads and higher tightening torques. It also compensates for higher tolerances.

Manufacturer Number:

HB31460US1

Contents:

• 1 x BEAST Components Hybrid Bar IR 31.8 handlebars