Spray.Bike Frame Builder's Carbon Primer

Frame Builder's Carbon primer by Spray.Bike - primer for your carbon bike

Frame Builder's Carbon Primer from Spray.Bike is a transparent primer specially developed for raw carbon frames. Treat your carbon or resin composite frame and then apply remarkably strong holding Spray.Bike paint!

Specifications:

Designation:

Spray Bike Acrylic Paint in Aerosol

Application Area:

frame, fork and all parts to be painted

Features:

• strong adhesion primer for Spray.Bike paints
• ideally suited for carbon
• no subsequent heat treatment necessary
• with 400 ml a common bicycle incl. fork can be treated with one layer

Application:

• use Spray.Bike only on clean, dry surfaces
• wear gloves, protective clothing and breathing mask
• always paint outdoors
• shake spray can vigorously for approx. 3 minutes before use
• take 2-3 test sprays before use
• spray only with a spray can in vertical position (at least 20 cm spray distance)
• keep the spray can moving at all times during the spraying process
• allow primer to dry completely (10 - 15 minutes)
• paint with desired colour and treat further

Manufacturer's Warning:

Optimum ambient temperature while spraying: 20-25°C. Do not use Spray.Bike at outside temperatures below 10°C, above 35°C or at a relative humidity level greater than 75%. Keep the can well-protected from sunlight and ambient temperatures above 50°C/122°F.

CLP Regulation Label:

Signal Word:

Danger

Hazardous Components:

acetones, cylenes, 2-methoxy-1-methylethyl acetate

Hazard Warnings:

H222 Extremely flammable aerosol.
H229 Pressurized container: may burst if heated.
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Safety Information:

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, naked flames and other sources of ignition. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P280 Wear protective gloves / protective clothing / eye protection / face protection.
P410+P412 Protect from sunlight. Do not expose to temperatures above 50 °C / 122 °F.
P501 Disposal of contents/container in accordance with local / regional / national /
international regulations.

Manufacturer:

Cosmos Lac AE
1 Pindou Street, Kallithea 17672, Athens. Greece
Phone: +30 2109570222
Fax: +30 2109566671
factory@cosmoslac.com
http://www.cosmoslac.com

Models:

400 ml:

Nominal Amount:

400 ml

Packaging Type:

spray can

Contents:

• 1 x Spray.Bike Frame Builder's Carbon primer